("forward to shoot forward.") You can now take your finger off the underside of the bolt. Hold the Receiver upside down, and slide Breech Bolt "up and in," held flush against the top of the receiver with your finger, against the Firing pin retractor (35) spring pressureīreech bolt rocker switch depressed forward with your screwdriver. This gun is designed to only need a 3/16th" hollow ground standard tip screwdriver to disassemble.Īssuming the Mag slides freely, slide the Mag, Action slide (25) and Action slide handle (28) ("Slide") forward about 4" until they all contact the "Mag flange:" ![]() Never use tools which generate excessive leverage. ![]() If that doesn't free it up, see a gunsmith. ![]() The Barrel above is shown popped out (the Mag band functioning like a "U-shaped" spring with the screws removed.) This is the normal way the Barrel is LATER STEP separated (and reinstalled ) from (to) the Mag.Īlso, the "Barrel flange" is shown, which goes into the Mag band and Magazine band bushing, (13) into mortises cut into them.Īs with everything on neglected guns, if something is stuck, soak overnight or longer with penetrating oil. ![]() The Barrel is fixed, the Mag is designed to slide forward and rearward through the (snug) Mag band, only when unlocked, to disengage the receiver for takedown. The Mag band should never make immovable contact with the Mag, but it does hold the Barrel tight when the two screws are installed, by design.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |